Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   - Forward suspension bracket
      Removal, dismantling, assemblage and installation of a nave and rotary fist
      Removal, dismantling assemblage and installation of a rack of a suspension bracket
      Replacement of a stretcher of petrol models
      Replacement of a stretcher of diesel models
      Removal and installation of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal, dismantling assemblage and installation of a rack of a suspension bracket


    Remove a forward wheel.
    Disconnect from the shock-absorber a rack of the stabilizer (3).
    Give two bottom nuts (4) fastenings of a rack to a rotary fist and clean aside the holder of electroconducting of the wheel gauge and a brake hose. Separate a rotary fist from a rack.
    Give three top bolts of fastening of a rack and remove assemblage of a rack of a forward suspension bracket.
    Clamp a rack in a vice and by means of the special adaptation compress a spring.
    Keeping the shock-absorber from проворачивания, give a counternut on its rod.

The reuse of a nut of fastening of a spring is not supposed.

    Remove the bearing and the top saddle of a spring (3), and also a spring, a rubber casing and the terminator of compression (4).
    Assemblage and installation are made upside-down. Pay attention to that the spring rested against a stopper on its bottom saddle.