Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   - Forward suspension bracket
      Removal, dismantling, assemblage and installation of a nave and rotary fist
      Removal, dismantling assemblage and installation of a rack of a suspension bracket
      Replacement of a stretcher of petrol models
      Replacement of a stretcher of diesel models
      Removal and installation of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Replacement of a stretcher of diesel models


    Tyre out the car on the lift, and cover wings protective covers. Remove an inlet air line and the top cover of the engine. Turn out a bolt of a back support of the engine and will hang out the engine. Lift the car and remove forward wheels. Remove the bottom protective casings of an impellent compartment.
    On models with the xenon headlights remove the gauge of loading from an arm and take him aside.
    Remove lateral protective casings of wheel arches and intermediate section of an exhaust pipe.
    Disconnect from a stretcher a support of the engine and suspension bracket levers.
    Remove from a stretcher the stabilizer of cross-section stability. Remove from a stretcher an air cleaner and the bottom protective casing of a radiator. Fasten a plait a radiator to its support and remove rubber holders of tubes of cooling ГУР.
    Turn out bolts of fastening of amplifiers of a stretcher (19), disconnect a sleeve of cooling of the accumulator, prop up a stretcher and turn out the remained bolts of its fastening (22).

Average bolts of fastening of a stretcher differ from other bolts and at installation should be rolled on former places.

    Remove a tube support интеркулера and lower a stretcher so that it was possible to turn out bolts of fastening of the steering mechanism. Liberate from holders of tube ГУР and К/В and remove a stretcher. Installation is made upside-down. Tighten fixture with demanded efforts.