Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of a nave of a back wheel
      Removal, dismantling, assemblage and installation of a rack of a suspension bracket
      Removal and installation of a stretcher and cross-section draughts
      Removal and installation of the stabilizer of cross-section stability
      Removal and installation of the longitudinal lever
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal, dismantling, assemblage and installation of a rack of a suspension bracket


    Поддомкратьте the car also remove a corresponding wheel.
    Turn out the bottom bolts of an arm of a rack and slightly give the top bolts.
    Turn out the bottom bolt of fastening of a rack (3) and remove it.
    Keeping the shock-absorber from проворачивания, slightly give a nut (5) fastenings of a spring.

The reuse of this nut is not admissible.

    Squeeze out downwards an arm (6) springs to unload the shock-absorber and definitively give a nut, a washer and the rubber plug. If necessary use the adaptation for spring compression. Remove the shock-absorber, a spring and the spring prorate. Assemblage and installation are made upside-down. Tighten fixture with demanded efforts.