Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of tips and protective covers of steering draughts
      Removal and installation of the steering mechanism and steering draughts
      Removal and steering wheel installation
      Removal and installation of assemblage of a steering column
      Removal and pump GUR installation
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal and installation of the steering mechanism and steering draughts

The description for petrol 4-cylinder engines is more low resulted. Removal and installation of the steering mechanism on other models is carried out similarly. At replacement of steering draughts the steering mechanism should lie on an equal strong surface and should not be loaded, since otherwise can be damaged a gear wheel and рейка.


    Pump out liquid ГУР from the tank and take him aside. Clear area round connection of a returnable tube to the tank of liquid ГУР, disconnect a returnable tube and place its end in capacity for gathering of liquid ГУР (on less than 1 litre). Поддомкратьте the car so that forward wheels did not concern the earths. Start the engine and rotate a steering wheel between extreme positions to pump out liquid ГУР from the steering mechanism. As soon as a liquid stream ослабнет, switch off the engine not to damage pump GUR. Закупорьте a hose and an aperture in the tank. Establish a steering wheel in position of rectilinear movement and fix it in this position. Turn out a bolt of fastening of a steering shaft to the steering mechanism and separate them, having pulled a shaft upwards.

The bolt can be turned out from under the panel of devices.

Dismantling of a steering shaft is not admissible.

    Uncover the inlet pipeline. Turn out bolts (2 on an illustration) fastenings of a back pillow of the engine to a stretcher and the central nut of fastening of a pillow to an engine support. Will hang out the engine for a back elevating eye, поддомкратьте the car and remove forward wheels. Remove tips of both steering draughts (see Has undressed Removal and installation of tips and protective covers of steering draughts). Remove the stretcher amplifier (5 on an illustration) and separate an exhaust pipe between каталитическим the converter and the muffler. Turn out average bolts (8 on an illustration) stretcher fastenings, lower its back part and remove an engine pillow.
    Disconnect submitting and returnable tubes from the case of the valve and cut couplers.
    Turn out two bolts (7 on an illustration) fastenings of the steering mechanism. Remove the steering mechanism through the right wheel arch. Do not damage protective casings of steering draughts. Remove protective covers of hinges of steering draughts and duster valve GUR.
    If necessary give накидную a nut of fastening of draught, keeping рейку.
    Installation is made upside-down. Use new sealing rings of connection of submitting and returnable tubes of valve GUR. Bolts of fastening of tubes tighten after bolts of the steering mechanism.

The washer of the right bolt of fastening of the steering mechanism is replaced with an arm of a submitting tube.