Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   - The external equipment and кузовные elements
      Removal and installation of bumpers
      Removal and installation of decorative lattices of a radiator
      Removal and installation of spoilers
      Removal and installation of a covering and the decorative panel of a cover of a luggage carrier
      Removal and installation локеров wheel arches
      Removal and installation of forward wings and обтекателя a windscreen
      Removal and installation of beams of the top luggage carrier of models the Versatile person
      Removal and installation of assemblage of the top hatch and its components
      Removal and installation of a cowl and its lock
      Removal, installation, dismantling and assemblage of a forward door and its components
      Removal, installation, dismantling and assemblage of a back door and its components
      Removal, dismantling, assemblage and installation of a door of a back and its components
      Removal and installation of a cover of a luggage carrier and its components
      The fixed glasses
   + The salon equipment
+ Onboard electric equipment

Removal and installation of a cowl and its lock


At removal and cowl installation it is necessary to secure with the help of the assistant.


    Open a cowl, ослабьте noise isolation fixture on a cowl left-hand side, extend a hose of a washer and separate it.
    Loosen the a collar (4) on a loop also extend a washer hose.
    Mark cowl position on loops and remove the top support of a rack of the cowl (6), established in the hinge on a cowl. Turn out on two bottom nuts (7) on each loop, and then give on pair turns the top nuts (8).
    Remove a cowl. If it is required to remove its loops, give their bottom nuts.
    Installation is made upside-down. If necessary transfer a noise isolation, consolidation and atomizers of washers on a new cowl. In summary adjust position of a cowl concerning a body – backlashes between them should be identical, and their height should coincide.
    Adjustment of position of a cowl in a longitudinal direction is made at three released nuts of a loop on the cowl party; adjustment of height of the back party of a cowl is made at three released nuts of a loop on the body party. For adjustment of height of a forward part of the party of a cowl give nuts (1) clamps, a screw-driver adjust their position and make corresponding adjustment of a rubber emphasis.

The cowl lock


    Open a cowl and remove a decorative lattice of a radiator.
    Turn out screws in the terminator of a cable and extend a cable from its plug and lock levers. Fix a stopper of a cable (3).
    Give nuts (2) and remove the lock. Will put the lock and, without fixing it, accurately close a cowl to level a latch with the lock. Open a cowl and fix the lock nuts. Insert a cable into one of springs and put on a stopper (3). Then insert a cable into the plug and in other spring (4) and put on a stopper. Make sure that the spring in the released position settles down opposite to a stopper (A) and that between a stopper and a spring there is a backlash. After installation adjust cowl position.