Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
   The general information and preparatory operations
   Check компрессионного pressure
   Check of the engine by means of the vacuum gauge
   - Repair of 4-cylinder petrol engines
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
      Removal and installation of a head of cylinders and натяжителя приводной chains
      Removal and installation of camshafts and valves, estimation клапанных backlashes
      Check and replacement приводной chains
      Replacement of a belt of a drive of auxiliary units
      Replacement of epiploons and pulley of a cranked shaft
      Replacement of the oil pump
      Removal and pallet installation картера
      Removal and installation of an arm of the filter, the thermostat and редукционного the valve of system of greasing of the engine
      Check of pressure of impellent oil
      Removal and installation of the power unit
      Removal and installation of a cover of drive ГРМ
      Check and replacement of a chain of a drive of balancing shaft and their asterisks
   + Repair of 6-cylinder petrol engines
   + Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and pallet installation картера

Removal of forward section of an exhaust pipe


    Remove a decorative cover of the engine, take щуп level of impellent oil and stop up its directing with rags. Disconnect electroconducting from ljambda-probes, disconnect перепускную a tube турбокомпрессора and remove a thermofilter over a final collector. Give 2 top nuts on an exhaust pipe (4 on an illustration). Поддомкратьте the car also remove the bottom protective casing of the engine. Then give the remained fixture (6) and remove forward section of an exhaust pipe.
    Remove a protective casing from transmission (7 on an illustration). Lower impellent oil and disconnect a hose сапуна картера (9 on an illustration) from the pallet картера.
    Give bolts of fastening of the pallet картера and remove it.

On models with engine B235R and Manual transmission for access to the latent bolts of fastening of the pallet картера drill apertures or beat out stoppers (depending on a year of release) in the places specified in illustrations A. The pallet acts in film by means of the lever with the pointed end (see illustration B).


Position of apertures or stoppers for access to the latent bolts.


Pallet branch картера from the block of cylinders of engine B235R.
    If the pallet картера acts in film for the purpose of replacement, rearrange маслоотражательную a plate and a tube on the new pallet. Thus use new sealing rings. Make sure of absence of a dirt in the pallet. Clear from old прокладочного a material the pallet картера and the block of cylinders. Put a pillow of hermetic in the thickness of 2 mm on an interfaced surface of the pallet картера. Check up that the bringing tube is correctly established on the place. Installation is made upside-down. After installation warm up the engine and make sure of absence of leaks through the pallet картера. If necessary modify level of impellent oil.