Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
   The general information and preparatory operations
   Check компрессионного pressure
   Check of the engine by means of the vacuum gauge
   + Repair of 4-cylinder petrol engines
   - Repair of 6-cylinder petrol engines
      Reduction of the piston of the first cylinder in position ВМТ and replacement of a belt of a drive of auxiliary units and it натяжителя
      Removal and installation of the inlet pipeline, belt of drive ГРМ and heads of cylinders
      Dismantling and assemblage клапанного the mechanism
      Replacement of epiploons of a cranked shaft
      Removal and pallet installation картера and маслоотражательной plates
      Replacement of the oil pump and its valves
      Replacement перепускного the valve of system of greasing of the engine
      Removal and installation of the power unit
   + Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and pallet installation картера and маслоотражательной plates


    Separate a socket of electroconducting of a ljambda-probe (1 on an illustration) and cut a cable coupler keeping it. Remember a route of a lining of electroconducting and take away it downwards. Give two top nuts of fastening of forward section of an exhaust pipe to турбокомпрессору.

Socket (1) ljambda-probes and section of a protective casing (3).

    Поддомкратьте the car also establish it on props. Remove the bottom back section of a protective casing of the engine (3 on an illustration). Remove forward section of an exhaust pipe.
    Lower impellent oil (5 on an illustration), give bolts of fastening of the pallet картера (6) and remove it.
    Remove маслозаборник (7 on an illustration) with a sealing ring and маслоотражательную a plate (8). Installation is made upside-down. Preliminary clear interfaced surfaces. If the sealing ring маслозаборника is damaged, use the new. On a carving of bolts of fastening маслоотражательной plates, маслозаборника and the pallet картера put fixing hermetic. Tighten fixture with demanded efforts.