Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   + System of cooling of the engine
   - Systems of heating, ventilation and air conditioning
      The general information
      Removal and installation of the block of management by system of ventilation from a heater and К/В, removal and installation of the broad valve
      Valve replacement отсечки a cooling liquid and it э/м the valve
      Removal and installation of the fan of a heater
      Removal and heat exchanger installation
      Removal, repair and compressor K/V installation
      Removal and installation of the gauge of temperature in salon
      Removal and installation of the step-by-step engine заслонки air and e/motor mixing заслонки an air circulation mode
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Valve replacement отсечки a cooling liquid and it э/м the valve

The given valves are riveted with each other.


    Uncover a broad tank and dump pressure in system. Substitute under the car capacity for gathering ОЖ.
    Press water hoses (3 on an illustration) and disconnect from valves vacuum hoses (4).

Check up at the same time a condition of hoses.

    Separate a socket (5 on an illustration) э/м the valve and cut the cable coupler (6) keeping together э/м the valve and electroconducting.
    Remove collars (7 on an illustration) fastenings of hoses to э/м to the valve and drill rivets (9).
    Replace the valve отсечки or it э/м the valve. Installation is made upside-down. Instead of rivets use болтовое connection.