Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
- Coupling and power shafts
   The general information
   - Coupling
      Removal, check and installation of assemblage of coupling
      Removal and installation of a pedal of coupling and its arm
      Removal and installation of the main and executive cylinders
      Prorolling of coupling and its executive cylinder
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Prorolling of coupling and its executive cylinder

Prorolling of a hydraulic drive of coupling


    Uncover the tank of a brake liquid and if necessary finish level of a liquid to demanded level.
    Give the union of prorolling (3) and connect to it a hose of the device for prorolling.
    Submit compressed air to the device for prorolling (5) and allow to leave a brake liquid before disappearance of bubbles then tighten the union.
    Establish on a cover of the tank of a brake liquid the special adapter and, keeping a hose of the device for prorolling on the union, pump over the tank within a minute or time necessary that air bubbles have risen on a surface. In summary check up coupling work.

Prorolling of the executive cylinder


For prorolling of the main cylinder of coupling Manual transmission should be removed.

    Connect to the union (1) submitting tubes of the executive cylinder a piece of a transparent hose in diameter of 8 mm and length 450 mm.
    Completely press and release выжимной the bearing (2). The piston of the executive cylinder should remain in the domestic situation. Fill a hose with a brake liquid on 350 mm and connect to it the manual pump. Create the pressure necessary that the piston of the cylinder and a brake liquid was put forward has started to move in the cylinder.

Do not suppose an exit of the piston from the cylinder further its full speed.

    Remove the pump and accurately press the piston against the stop. Allow to leave liquids with air bubbles. Repeat the actions described in paragraphs 9 and 10 before disappearance in the leaving liquid of air bubbles. After the prorolling termination leave the piston in its domestic situation.