Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   The general information and security measures
   Prorolling of brake system and replacement of a brake liquid
   Replacement brake колодок
   Removal and installation of brake disks
   Removal and installation of brake supports
   Removal and installation of a pedal of a brake
   Removal and installation of the vacuum pump
   Removal and installation of the tank of a brake liquid and ГТЦ
   Removal and installation of brake lines
   Removal and installation of components of a lay brake and its drive
   Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of brake supports


    Removal of forward supports, and also back floating supports with анкерной скобы is described in Section Replacement brake колодок. For definitive removal of a support it is necessary to disconnect a brake hose from it. After a hose detachment закупорьте its open end and an aperture in a support.
Fastening (6) forward supports to анкерной скобе and connection (5) hoses with a support.
    Before to disconnect a brake hose from a back floating support, the hose should be disconnected from a brake tube. For this purpose remove a clamp, disconnect a hose from a tube and закупорьте a tube.
    For removal of a motionless back support remove brake колодки (the Section Replacement brake колодок see), disconnect from a support a brake tube and turn out its fixing bolts (see an illustration).

The open end of a tube and aperture in a support закупорьте that the dirt has not got to them.

    At connection of a brake hose to a support (forward and back floating supports) watch that the hose has not been overwound. After support installation pump over brake system.