|
|
Saab 9-5Since 1997 of releaseRepair and car operation |
|
|
Saab 9-5 + Cars Saab 9-5 + Controls and operation receptions + Options and car routine maintenance + The engine + Systems of cooling of the engine, heating, ventilation and air conditioning + The power supply system and release of the fulfilled gases + Systems of an electric equipment of the engine + Manual box of a gear change + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering The general information, recommendations and security measures + Forward suspension bracket + Back suspension bracket + Steering - Suspension bracket geometry Corners of installation of wheels of the car - the general information Check and adjustment of corners of installation of wheels + Body + Onboard electric equipment |
Suspension bracket geometry Corners of installation of wheels of the car - the general information Corners of installation of wheels appreciably influence stability of the car, deterioration of tyres and the fuel expense. Rating values of corners are resulted in Specifications. As disorder is called the angle of slope of a plane of a wheel concerning a vertical. If wheels are inclined by upper edges outside, disorder is called as positive. The disorder size is measured in degrees. Correctness of adjustment of disorder defines size and position of a stain of contact of a protector with a road covering and allows to compensate changes in geometry the suspension brackets occurring during fulfilment of turns and at movement of the car on a rough road covering. Disorder of forward wheels As convergence (convergence) is called the data size to each other forward edges of wheels of the car (=B-A). Such infringement of parallelism of installation of wheels allows to minimise deterioration of a protector for the prevention account юза at fulfilment of turns. Infringement of adjustment of convergence conducts to acceleration of deterioration of protectors of tyres for the account проскальзывания them on a road covering. Convergence of forward wheels Выбегом the corner of a longitudinal inclination of an axis of turn of a wheel, i.e. a corner of a deviation of the given axis from a vertical in a plane of a wheel disk is called. If the turn axis is inclined back, выбег is called as positive, and on the contrary. Выбег forward wheels The corner of a cross-section inclination of an axis of turn of a wheel - a corner of a deviation of the given axis from a vertical if to look at a wheel in front or behind the car. If the turn axis is inclined inside, the given corner is considered positive. Corner of a cross-section inclination of an axis of turn of a forward wheel The size of limiting angles of rotation of forward wheels of the car should be lowered at increase in the size of the last. Limiting angles of rotation of forward wheels |
|