Saab 9-5

Since 1997 of release

Repair and car operation



Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
- Manual box of a gear change
   Transmission identification
   The general information
   Removal and installation of a casing of the lever of a gear change
   Adjustment, removal and installation of a drive of a gear change and the ignition lock
   Replacement of the handle of the lever of a gear change
   Removal and installation Manual transmission of 4-cylinder engines
   Removal and installation Manual transmission of diesel engines V6
   Removal and installation Д/В of lanterns of a backing
   Replacement of epiploons of power shafts
   Design and transmission major repairs
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement of the handle of the lever of a gear change

The reuse of the removed handle is not supposed.


 PERFORMANCE ORDER

    Remove the gear change lever (the Section Adjustment, removal and installation of a drive of a gear change and the ignition lock see) and clamp it in a vice. Wind with a tape a neck under the handle, establish on a tape рожковый a key on 32 mm and slightly strike on it from below a hammer to bring down the handle with the holder from the lever.
    Remove a tape, and then remove the handle from the holder, having pressed a thin screw-driver clamps on the holder.

Pay attention to that under the handle the spring is established.

    Installation is made upside-down.