Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
- Systems of an electric equipment of the engine
+ Systems of ignition, preheat and engine management
+ Diagnostics of systems of electronic control and the diagnostic equipment
- Charge and start systems
The general information
The storage battery - the general information, recommendations about service
Charge system - the general data and security measures
Removal and generator installation
Replacement of the block of the rectifier of pressure and generator brushes
System of start of the engine - the general information and safety measures
Removal and starter installation
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and generator installation
Details of assemblage of the generator are shown on an illustration.
Generator assemblage
Disconnect a negative wire from the battery.
4-cylinder engines
|
|
|
|
Remove a casing (3 on an illustration) over the inlet pipeline, э/м the valve (4) ventilations картера and valves of constant pressure.
|
Loosen the a tension (5) belts of a drive of auxiliary units also remove it then turn out the top bolt of the generator (6).
Mark and give a nut (7) right support of the engine.
Give a nut of a back support of the engine.
Remove a lobby of section of an exhaust pipe (see the Head of the Power supply system and release of the fulfilled gases) and a hose between the pallet картера and an oil separator.
|
|
Disconnect electroconducting from contacts B + and D + the generator and turn out the bottom bolt of the generator.
|
Turn the generator downwards, between the steering mechanism and intermediate shaft, then insert распорку between a transmission and a stretcher and remove the generator
Installation is made in an order, the return to an order of dismantle of components.
|
|
Petrol engine V6
|
|
Loosen the a tension of a belt of a drive of auxiliary units also remove it натяжитель.
Remove the right forward wheel.
Remove the bottom protective casing of a wheel arch.
|
|
Turn out 6 bolts of a pulley (7 on an illustration), remove Д/В pressure of impellent oil (8) and the right power shaft (9).
|
|
|
Закупорьте an aperture under Д/В pressure of impellent oil. |
Disconnect from the generator electroconducting and a sleeve of air cooling.
Give 2 bolts of fastening of the generator and remove it through the right wheel arch.
Installation is made in an order, the return to an order of dismantle of components.
|
|
The diesel engine
|
|
|
|
Loosen the a tension of a belt of a drive of auxiliary units also remove a belt from pulleys.
|
|
|
Disconnect from the generator electroconducting, turn out bolts of its fastening and remove the generator.
|
Installation is made in an order, the return to an order of dismantle of components.
|
|
|
|