Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
The general information, recommendations and security measures
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of a nave of a back wheel
Removal, dismantling, assemblage and installation of a rack of a suspension bracket
Removal and installation of a stretcher and cross-section draughts
Removal and installation of the stabilizer of cross-section stability
Removal and installation of the longitudinal lever
+ Steering
+ Suspension bracket geometry
+ Body
+ Onboard electric equipment
|
Removal and installation of the longitudinal lever
|
|
Поддомкратьте the car also remove wheels.
Squeeze out the piston of the brake cylinder, turn out bolts of fastening of a brake support and suspend it on a body (see Has undressed Removal and installation of brake supports).
|
|
Remove air дефлектор (4), turn out a bolt (5) fastenings of an arm of a cable of a drive of a lay brake, separate a socket of the wheel gauge (6) and liberate its electroconducting from the holder.
|
Turn out nuts of the holder of electroconducting of the wheel gauge and a brake tube (8).
|
|
Turn out the bottom bolt (9) fastenings of a rack of a suspension bracket and a bolt (10) fastenings of the bottom cross-section bent for to a rotary fist.
|
Unhook a returnable spring of a cable of a drive of a lay brake and remove a cable (11).
Turn out bolts (12 and 13) fastenings of the stabilizer and the top bent for to the longitudinal lever.
|
|
Turn out bolts of fastening of the longitudinal lever to a body and lower the lever together with a nave and a brake disk.
|
Turn out from the longitudinal lever a nave with a brake disk.
|
|
Establish on the longitudinal lever the special adaptation (16), turn out a bolt (17) and remove from the lever the special adaptation and an arm.
|
Installation is made upside-down. Use new bolts of fastening of a nave.
|
|
|
|