Saab 9-5

Since 1997 of release

Repair and car operation



Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
- Automatic transmission
   The general information
   Search of malfunctions - the general information
   Removal and installation of assemblage of the lever of the selector of modes АТ and its casing
   Removal, installation and adjustment of a cable of the selector of modes АТ
   Removal and installation of the lever of the selector of modes АТ and dismantling of its casing
   Removal and installation э/м valves AT, their case and its cover
   Removal and installation of gauges of speed
   Removal and installation of hydraulic lines АТ
   Removal and installation TCM
   Replacement and adjustment of the gauge of position of the selector of modes АТ
   Removal and installation АТ
   Replacement of epiploons of power shafts
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement and adjustment of the gauge of position of the selector of modes АТ

Replacement

 PERFORMANCE ORDER

    Remove the storage battery together with its pallet.
    Clear area round a joint of jellied tube ATF with АТ and lift the receiver (4).
    Establish the lever in position L, give a nut (5) and remove the lever (6). Turn out bolts (7) fastenings of the gauge of position of the selector of modes АТ, разконтрите and give a nut (8) fastenings of the gauge. Separate a socket of the gauge and remove it from a shaft. Installation is made upside-down.

At first tighten bolts, and then a gauge nut.

Adjustment

 PERFORMANCE ORDER

    For adjustment the special adaptation is required. Establish АТ in a mode N, give bolts of fastening of the gauge and place on it the special adaptation.
    Move the gauge to position in which the label on it would coincide with a cut on the adaptation.