Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of a nave of a back wheel
      Removal, dismantling, assemblage and installation of a rack of a suspension bracket
      Removal and installation of a stretcher and cross-section draughts
      Removal and installation of the stabilizer of cross-section stability
      Removal and installation of the longitudinal lever
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal and installation of a stretcher and cross-section draughts

Removal

At removal of one of cross-section draughts of a suspension bracket described below operation it is enough to make only on one party of the car. At removal of the top draught it is required to remove the bottom draught.


 PERFORMANCE ORDER

    Поддомкратьте the car also remove back wheels. Unhook an exhaust pipe from central and back rubber подвесов and suspend it so that not too strongly to load lobbies подвесы and flexible section.
    Turn out fastening bolts at first bottom (3), and then the top (4) cross-section bent for to the longitudinal lever from both parties of the car.
    From both parties of the car turn out bolts (5) fastenings of the stabilizer to cross-section draught.
    Turn out bolts of fastening of a stretcher (6) and lower it together with the stabilizer and cross-section draughts then remove from it draughts (7) and the stabilizer (the Fixture of components of a back suspension bracket (the right party, the top view see an illustration)). If necessary replace plugs of components of a suspension bracket.

Installation

 PERFORMANCE ORDER

    Fix on a stretcher the stabilizer and cross-section draughts. Fixture of draughts yet do not tighten definitively.

Use new bolts of fastening of bent for to a stretcher.

    Establish into place assemblage of a stretcher with draughts and the stabilizer. Stretcher fixture yet do not tighten definitively. Fix on longitudinal levers the stabilizer, and then the top and bottom draughts. Tighten bolts of fastening of a stretcher. Establish an exhaust pipe on rubber подвесах, establish wheels and lower the car on the earth. Tighten bolts of fastening of bent for to a stretcher.

At a tightening of bolts the car should stand on the earth on all wheels.

    Check up convergence of back wheels and if necessary adjust it (the suspension bracket Geometry see).