Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   The general information, recommendations and security measures
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   - Suspension bracket geometry
      Corners of installation of wheels of the car - the general information
      Check and adjustment of corners of installation of wheels
+ Body
+ Onboard electric equipment

Check and adjustment of corners of installation of wheels

The general check of geometry of a suspension bracket is made at the special stand in the conditions of a specialised workshop.

Convergence

Before adjustment of convergence of forward wheels make sure of correctness of adjustment of convergence of back wheels.

Adjustment of convergence of back wheels is carried out by moving of arms of longitudinal levers of a suspension bracket outside (convergence reduction) or inside (convergence increase) at slightly released fixture of arms.

Convergence of forward wheels is carried out by change of length of steering draughts.

Disorder of back wheels

Disorder of back wheels is regulated by installation between the longitudinal lever of a suspension bracket and a nave special прокладочных plates: on the top bolts of fastening of a nave in case of the overestimated disorder or on the bottom bolts at the underestimated disorder.

Installation only one plate is supposed.

Other corners

Other corners of installation of wheels are not regulated. If necessary replace defective components of a suspension bracket.