Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
The general data and security measures
Sbrasyvanie pressure in fuel system
- The power supply system of petrol engines
Principle of functioning of a control system of fuel injection
Removal and installation of a sleeve of an air inlet and the case of the air filter
Removal and installation of gauges MAF, MAP, IAT and the gauge of temperature/pressure of air of pressurisation
Removal and installation of a tube of forced air
Removal and installation of the case of a throttle
Removal and installation of the control valve of forced air
Removal and installation перепускного the valve турбокомпрессора
Removal and installation турбокомпрессора
Removal and installation интеркулера
Removal and installation of a pedal of gas, adjustment of a cable of a drive throttle заслонки
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of assemblage of the fuel pump and the gauge of a stock of fuel
Removal and installation of a fuel distributive highway and injectors
Removal and installation of a regulator of pressure of fuel
+ The power supply system of diesel engine V6
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assemblage of the fuel pump and the gauge of a stock of fuel
|
|
Execute the actions described in the item with 1 on 4 Has undressed Removal and installation of a fuel tank.
|
|
By means of the special adaptation turn out a carving ring.
|
Raise the fuel pump so that its top part towered approximately on 5 sm over a fuel tank then turn the pump on an hour arrow on a corner approximately on 80 hailstones. Also remove the pump from a tank.
|
|
Prepare to вытеканию a fuel small amount. |
Check up conformity of parametres of the fuel pump and the gauge of a stock of fuel to requirements of Specifications. The float of the gauge of a stock of fuel should be on distance 0 - 3 mm from the bottom plane of the fuel pump.
If necessary carry assemblage out repairs according to an illustration.
|
1 — the Pump
2 — Ezhektor
3 — the Filter
4 — the Tank
5 — the Submitting line of the pump
6 — the Returnable line
7 — a pump Cover
8 — the Sealing ring
9 — the Spring element
10 — the Carving ring
11 — the Filter of a radio noise |
Clear interfaced surfaces and establish in a groove of a fuel tank a new sealing ring.
The further installation is made upside-down. If necessary replace sealing rings of connections of fuel hoses with the pump.
|
|
|
|