Saab 9-5

Since 1997 of release

Repair and car operation



Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   - System of cooling of the engine
      The general information and safety measures
      Removal and installation of the water pump
      Removal and thermostat installation
      Removal and installation of assemblage of fans of a radiator
      Fan replacement
      Removal and radiator installation
      Removal and installation маслоохладителя 4-cylinder petrol engines
      Removal and installation of a broad tank
   + Systems of heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and thermostat installation

4-cylinder petrol engines

 PERFORMANCE ORDER

  1. Open a cover of a broad tank and dump pressure in cooling system.
  2. Поддомкратьте the car also remove the bottom protective casing of an impellent compartment.
  3. Lower cooling liquid and lower the car on the earth.
  4. Loosen the a collar of fastening of the top hose of a radiator to the case of the thermostat also remove a hose.
  1. Disconnect from the case of the thermostat a weight wire, give the top bolt of fastening of the case and completely turn out the bottom bolts of its fastening.
  1. Remove the case of the thermostat and the thermostat.
  1. Check up a condition of interfaced surfaces and clear them. Slightly grease rubber consolidation безкислотным with vaseline.
  2. At thermostat installation make sure that its ventilating aperture is above (a label «TOP» on the thermostat).
  3. The further installation is made upside-down.

Petrol engines V6

 PERFORMANCE ORDER

  1. Execute the actions described in paragraphs 1-3, and remove the top cover of the engine.
  1. Remove top, then average and bottom sections of the inlet pipeline.
  1. Remove gauge MAF and шaланг, disconnect submitting tube турбокомпрессора and shift it in a direction to интеркулеру.
  2. Disconnect перепускную a tube турбокомпрессора and separate a socket on a ventilation tube картера.
  1. Take щуп level of impellent oil and disconnect a hose from the thermostat. Remove the thermostat together with its case.
  1. Check up a condition of interfaced surfaces and clear them. Replace a sealing ring of the thermostat.
  2. The further installation is made upside-down.

Diesel engines V6

 PERFORMANCE ORDER

  1. Remove assemblage of fans of a radiator (see Has undressed Removal and installation of assemblage of fans of a radiator).
  1. Remove a thermofilter of a final collector (2 on an illustration).
  1. Substitute under the car suitable capacity and disconnect a hose from the thermostat case (3 on an illustration).
  2. Remove the case of the thermostat and the thermostat (4 and 5 on an illustration).
  3. Establish the thermostat with new consolidation, having made sure that the purge valve is above.
  4. The further installation is made upside-down.