Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   + System of cooling of the engine
   - Systems of heating, ventilation and air conditioning
      The general information
      Removal and installation of the block of management by system of ventilation from a heater and К/В, removal and installation of the broad valve
      Valve replacement отсечки a cooling liquid and it э/м the valve
      Removal and installation of the fan of a heater
      Removal and heat exchanger installation
      Removal, repair and compressor K/V installation
      Removal and installation of the gauge of temperature in salon
      Removal and installation of the step-by-step engine заслонки air and e/motor mixing заслонки an air circulation mode
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the fan of a heater

 PERFORMANCE ORDER

    Switch off a mode of circulation and switch off ignition. Remove levers of screen wipers and rubber consolidations from their spindles. Disconnect from the centre of a partition of an impellent compartment its consolidation.

Lateral clamps do not remove.

    Remove обтекатель a windscreen. For a detachment обтекателя from glass pull обтекатель forward. Liberate a water filter from clamps and remove it. Turn out 4 bolts of fastening of the mechanism of screen wipers and remove it, having separated a socket.
    Give 2 nuts on forward to edge of a framework round the heater fan, liberate it from two clamps and remove it (9 on an illustration).
    Turn out 3 bolts and remove an arm of levers of screen wipers (10 on an illustration), located over the heater fan.
    Disconnect burn down electroconductings from a fan cover (11 on an illustration), turn out 4 bolts and uncover (12).
    Raise the heater fan, separate its socket and cut cable couplers of its electroconducting (13 on an illustration). Extend the fan sideways. Installation is made upside-down.