Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
The general data and security measures
Sbrasyvanie pressure in fuel system
+ The power supply system of petrol engines
+ The power supply system of diesel engine V6
- Systems of release and decrease in toxicity of the fulfilled gases
The general information
Removal and installation of components of system of release ОГ
Removal and installation of ljambda-probes
Removal and installation of components of system SAI
Removal and installation of components of system EVAP
Removal and installation of the valve and system EGR tube
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of components of system EVAP
The gauge of pressure of steams of fuel
|
|
Remove a fuel tank and clear area round the pressure gauge the compressed air.
|
|
Turn out the screw of fastening of the gauge, disconnect from it electroconducting and remove the gauge.
|
Installation is made upside-down. Preliminary make sure of cleanliness of interfaced surfaces and grease a sealing ring of the gauge безкислотным with vaseline.
|
|
Adsorber
|
|
Remove a fuel tank.
|
|
Disconnect from an adsorber a line of a purge and a valve hose отсечки (2 on an illustration).
|
Disconnect lines from a fuel tank to an absorber (3 on an illustration). For this purpose at first press a socket in a direction to an absorber (a), then compress clamp pads (b) and disconnect a hose ().
By means of the special adaptation ослабьте a hose of a purge of an adsorber.
Give fixture (5 on an illustration) and remove an adsorber.
Installation is made upside-down. Watch correctness and reliability of connection of hoses.
|
|
The valve отсечки
|
|
|
|
Поддомкратьте the car, cut a cable coupler (2 on an illustration), separate and remove a socket (3) devices of a purge.
|
By means of a screw-driver disconnect the device of a purge from an arm of a jellied tube (4 on an illustration). Clear the purge device.
Remove the top cover of the valve отсечки (6 on an illustration).
|
|
Separate a valve socket отсечки and remove a washer (7 on an illustration).
|
Shift a cover (8 on an illustration) so that to provide access to a collar (9), ослабьте a collar and remove the valve.
Installation is made upside-down.
|
|
The valve of a purge of an adsorber
|
|
|
|
Loosen the quick disconnect connection of a hose of a purge of an adsorber (1 on illustrations) also remove the valve of a purge (2) from an arm.
|
|
|
Removal of the valve of a purge on petrol engines V6. |
Accurately turn the valve and separate its socket (3 on illustrations) then disconnect the valve from a hose (4).
Installation is made upside-down.
|
|
|
|