Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
- Coupling and power shafts
   The general information
   + Coupling
   - Power shafts
      Removal and installation of power shafts
      Dismantling, assemblage and cleaning of hinges of power shafts
      Removal and installation of an intermediate shaft and its bearing
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of an intermediate shaft and its bearing

The description for 4-cylinder petrol engines is more low resulted. Removal and installation of an intermediate shaft and its bearing on models with other engines is made similarly. On petrol models V6 in addition it is required to remove a sleeve of cooling of the generator, and on diesel models V6 – lateral and the bottom protective casings of an impellent compartment.


 PERFORMANCE ORDER

    Cover wings protective covers and disconnect a negative wire from the battery. Поддомкратьте the car also remove the right forward wheel.

4-cylinder engines

 PERFORMANCE ORDER

    Uncover a belt of a drive of auxiliary units.
    Remove the top cover of the engine and a collar of tube ГУР. Insert a wedge between the pallet картера the engine and a stretcher and remove the top arm of the engine. By means of the special adaptation compress натяжитель a belt of a drive of auxiliary units and remove a belt. Remove натяжитель (the Engine see the Head). Turn out the top bolt of fastening of the generator (see the Head of System of an electric equipment of the engine).
    Loosen the a collar of a brake hose and fixture of electroconducting ABS (10).
    Turn out a bolt (1) fastenings of the lever of a suspension bracket to a rotary fist and beat out a hammer with soft brisk a power shaft from an intermediate shaft (12). Lower the lever of a suspension bracket and fix it in this position by means of wooden бруска, having established it between the lever and a rack of the stabilizer of a suspension bracket. Turn a wheel to the left for maintenance of the best access to a power shaft and beat out it further away if it is necessary. Then pull for a rack of a suspension bracket and lower a power shaft on the suspension bracket lever. Give nuts of fastening of electroconducting of the generator and turn out the bottom bolt of its fastening. Clean the generator aside. Turn out bolts (20 and 15) fastenings of an arm of the bearing of an intermediate shaft (21 and 16), remove an arm with directing and take an intermediate shaft from transmission.
Fixture of an arm of the bearing of an intermediate shaft on petrol models.
Fixture of an arm of the bearing of an intermediate shaft on diesel models.

Thus oil will follow from transmission.

    Replace an epiploon of an intermediate shaft in transmission (the Manual box of a gear change see the Head). In need of bearing replacement fix a shaft in a vice and remove a small lock ring.
Replacement of the bearing of an intermediate shaft by petrol models.

On diesel models remove the holder of the bearing and a lock ring.


Replacement of the bearing of an intermediate shaft by diesel models.
    By means of the special adaptation выпрессуйте a shaft from the bearing, remove the big lock ring (only on petrol models) and выпрессуйте the bearing from an arm. Installation is made upside-down. Before shaft installation in transmission be convinced that it pure.