Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
- Brake system
The general information and security measures
Prorolling of brake system and replacement of a brake liquid
Replacement brake колодок
Removal and installation of brake disks
Removal and installation of brake supports
Removal and installation of a pedal of a brake
Removal and installation of the vacuum pump
Removal and installation of the tank of a brake liquid and ГТЦ
Removal and installation of brake lines
Removal and installation of components of a lay brake and its drive
Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of components of a lay brake and its drive
The lever of a drive of a lay brake
|
|
Поддомкратьте the car, from each party remove a returnable spring and unhook cables of a lay brake from it разводных levers. Lower the car on the earth.
Remove the central console and a casing from the lever of a lay brake (the Body see the Head).
|
|
Separate a socket of the gauge of the cocked lay brake (5) and remove a collar (6) electroconductings.
|
Give 4 nuts of fastening of the lever of a lay brake (7), lift it and accurately extend upwards in salon equalizer assemblage.
Turn a tip of a cable of a lay brake on a corner 90 hailstones. Also separate it from the equalizer (9).
Installation is made upside-down. After installation adjust a lay brake (the Section Check of brake system see).
|
|
Cables of a lay brake
|
|
Release a lay brake and поддомкратьте the car.
Separate forward section of an exhaust pipe from back section (see the Head of the Power supply system and release of the fulfilled gases).
|
|
Remove left подвес (4) exhaust pipes, turn out two back fixing nuts (5) on the left side of a thermofilter (6) and unbend it to provide access to the equalizer.
|
|
|
From each party of the car remove a returnable spring and unhook cables of a lay brake from it разводных levers (7). Disconnect a cable from the equalizer, having turned its tip on a corner 90 hailstones. (8).
|
Extend a cable from the forward holder.
|
|
Поддомкратьте a fuel tank, ослабьте collars of its fastening also remove cables.
|
Installation is made upside-down. Stack cables on their original route. After installation adjust a lay brake (the Section Check of brake system see).
|
|
Boots of a lay brake
|
|
Remove corresponding a back brake disk (the Section of the Power supply system and release of the fulfilled gases see).
From each party of the car remove a returnable spring and unhook cables of a lay brake from it разводных levers (7).
|
|
Remove internal returnable springs and keeping pins (4).
|
Remove boots and the adjusting block (5).
Examine разводные levers (6) and the adjusting block on presence of damages and deterioration and if necessary replace them.
Installation is made upside-down. After installation adjust a lay brake (the Section Check of brake system see).
|
|
|
|