Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
- Brake system
The general information and security measures
Prorolling of brake system and replacement of a brake liquid
Replacement brake колодок
Removal and installation of brake disks
Removal and installation of brake supports
Removal and installation of a pedal of a brake
Removal and installation of the vacuum pump
Removal and installation of the tank of a brake liquid and ГТЦ
Removal and installation of brake lines
Removal and installation of components of a lay brake and its drive
Removal and installation of components of auxiliary systems (ABS/TC/ESP)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the vacuum pump
The vacuum pump with a mechanical drive
|
|
|
|
Remove the top cover of the engine (1) and disconnect a hose (2) from турбокомпрессора.
|
Turn out a bolt (3) fastenings перепускной tubes to an entrance tube турбокомпрессора, remove перепускной the valve (4) from a delivery tube. Separate a socket of the gauge of temperature on a delivery tube.
|
|
Loosen the collars of the case of a throttle and a delivery air hose (7). Turn out a bolt (7) fastenings of a delivery tube to an arm on a head of cylinders and lift the receiver. Cover the case of a throttle and a hose.
|
|
|
Disconnect a vacuum hose (8) from the vacuum pump and separate a socket (9) modules of ignition.
|
Remove the union of greasing of the pump and collect the flowed out oil (10).
|
|
Remember position of the vacuum pump and an axis concerning a groove. At installation this position should be recreated. |
Turn out 3 bolts (11) fastenings of the vacuum pump and remove the pump.
Installation is made upside-down. The union of greasing of the pump and bolts of fastening of the pump at first tighten, and then with demanded efforts, and at first it is necessary to tighten bolts of fastening of the pump to a head of cylinders, and then to an arm.
|
|
The electric vacuum pump
|
|
Поддомкратьте the car also remove a protective casing of an impellent compartment.
Separate a pump socket, ослабьте a collar of a vacuum hose and disconnect it from the pump.
Give nuts of rubber support and remove the pump.
Installation is made upside-down.
|
|
The vacuum pump of diesel engines
|
|
Turn out a bolt of fastening of an air line to the right support of the engine, remove an air line with турбокомпрессора and take him aside.
Remove vacuum hoses.
|
|
The hose from the amplifier of brakes has quick disconnect connection (4). |
|
|
Removal of the vacuum pump of the diesel engine. |
Turn out bolts (5) fastenings of the vacuum pump (6) and remove it.
|
|
Be convinced that directing plugs remained in the pump case. Pay attention that the bolts rolled in directing plugs are longer than the others. |
Installation is made upside-down.
|
|
|
|