Saab 9-5

Since 1997 of release

Repair and car operation



Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
   The general data and security measures
   Sbrasyvanie pressure in fuel system
   + The power supply system of petrol engines
   - The power supply system of diesel engine V6
      The general information
      Removal and installation of a sleeve of an air inlet, the case of the air filter and gauge MAF
      Removal and installation of the inlet pipeline
      Replacement of the gauge of position of a pedal of gas
      Replacement of gauges of a turbo-supercharging and the gauge of temperature of fuel
      Replacement of the valve of management with pressure of pressurisation
      Removal and installation турбокомпрессора
      Removal and installation интеркулера
      Removal and installation of a fuel tank
      Replacement of the fuel filter
      Removal and installation of a fuel distributive highway
      Removal and installation of the gauge of a stock of fuel
      Removal and installation ТНВД and replacement of its epiploon
      Removal and installation of atomizers
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the gauge of a stock of fuel

 PERFORMANCE ORDER

  1. Establish the car on an equal platform, lift a pillow of a back seat and unbend a sexual covering.
  1. Uncover (2 on an illustration) the gauge of a stock of fuel, separate its socket (3) and cut a cable coupler.
  1. Disconnect two contacts from a brown socket (4 on an illustration).
  2. Accurately disconnect from a fuel tank control valves and fuel lines, preliminary having marked their position not to mix at installation.
  3. Turn out a screw ring.
  4. Raise fuel capacity in gathering with the gauge of a stock of fuel so that its top part towered approximately on 5 sm over a fuel tank then turn assemblage on an hour arrow on a corner approximately on 80 hailstones. Also remove it from a tank.

Prepare to вытеканию a fuel small amount.

  1. Clear interfaced surfaces and establish in a groove of a fuel tank a new sealing ring.
  2. The further installation is made upside-down. If necessary replace sealing rings of connections of fuel hoses with the pump.