Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
The general data and security measures
Sbrasyvanie pressure in fuel system
+ The power supply system of petrol engines
- The power supply system of diesel engine V6
The general information
Removal and installation of a sleeve of an air inlet, the case of the air filter and gauge MAF
Removal and installation of the inlet pipeline
Replacement of the gauge of position of a pedal of gas
Replacement of gauges of a turbo-supercharging and the gauge of temperature of fuel
Replacement of the valve of management with pressure of pressurisation
Removal and installation турбокомпрессора
Removal and installation интеркулера
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of a fuel distributive highway
Removal and installation of the gauge of a stock of fuel
Removal and installation ТНВД and replacement of its epiploon
Removal and installation of atomizers
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation ТНВД and replacement of its epiploon
|
|
Поддомкратьте the car also remove the bottom protective casing of an impellent compartment.
Loosen the a tension of a belt of a drive of auxiliary units also remove it натяжитель (the Engine see the Head).
Give a forward bolt of a forward support of the power unit.
Lower the car and remove submitting tube from турбокомпрессора (1 and 2 on an illustration). Remove the top cover of the engine.
|
|
Give quick disconnect connections of fuel lines (7 on an illustration), unload support of the engine and remove the right support (8) together with an arm and a pillow. Slightly raise the engine to take bolts.
|
Remove a belt of a drive of auxiliary units and its intermediate pulley (the Engine see the Head).
Remove top section of the inlet pipeline and a fuel distributive highway with tubes (see Has undressed Removal and installation of the inlet pipeline).
Remove cogwheel ТНВД, a pulley of a cranked shaft and an intermediate pulley (the Engine see the Head).
If necessary only replacements of epiploon ТНВД make it at the given stage.
|
|
Remove valve EGR and a water hose.
|
Remove the bottom section of the inlet pipeline from both heads of cylinders (see Has undressed Removal and installation of the inlet pipeline).
|
|
Закупорьте an aperture in a head of cylinders also remove a ventilation hose картера. For simplification of installation and prevention of possible damages separate socket ТНВД (26 on an illustration).
|
Disconnect fuel lines (27) from ТНВД.
|
|
Turn out blocking bolt from gear wheel ТНВД and screw in it two bolts М6.
|
Tighten bolts consistently, that ослабла an external part of a gear wheel.
Screw bolts in apertures in an internal part of gear wheel ТНВД and remove it.
|
|
Remove ТНВД, paying attention to an arrangement of bolts of different length.
|
Installation is made upside-down. Use new lining ТНВД and new consolidations of understanding connections.
|
|
|
|