Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
- Coupling and power shafts
   The general information
   - Coupling
      Removal, check and installation of assemblage of coupling
      Removal and installation of a pedal of coupling and its arm
      Removal and installation of the main and executive cylinders
      Prorolling of coupling and its executive cylinder
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a pedal of coupling and its arm

Before to start removal of a pedal of coupling establish seats in their extreme back position.


 PERFORMANCE ORDER

    Remove components.

Providing of access to the main cylinder of coupling

1 — the Storage battery
2 — the Assembly block of the relay and safety locks
3 — the Block of fusible inserts and the switch of anticreeping system
4 — the Arm of the assembly block
    From an impellent compartment turn out 4 nuts of fastening of the main cylinder of coupling and an arm of a pedal of coupling.
    Remove the panel of devices entirely (the Body see the Head).
    Remove a knee emphasis under a steering wheel.
    Separate socket Д/В of a pedal of coupling (9) and turn out bolts (10) fastenings of an arm of a pedal to an intensifying beam.
    Unhook from a pedal a spring (11), remove a clamp (12) and take an axis.
    Disconnect a steering shaft from the steering mechanism (13).

Dismantling шлицевого the hinge of a steering shaft is not supposed.

    Give fixture (1) intensifying beams and delay it back so that it was possible to remove a pedal arm. Remove an arm. Installation is made upside-down.