Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
- Coupling and power shafts
The general information
- Coupling
Removal, check and installation of assemblage of coupling
Removal and installation of a pedal of coupling and its arm
Removal and installation of the main and executive cylinders
Prorolling of coupling and its executive cylinder
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the main and executive cylinders
The main cylinder
|
|
Remove the bottom left part of the panel of devices (under a steering wheel).
Remove from a pedal of coupling a spring, then remove a clamp and take out a pin.
Remove the storage battery. On diesel models V6 remove the top thermofilter турбокомпрессора.
Clean aside the assembly block of the relay and safety locks in an impellent compartment.
Pump out a brake liquid from the prorolling union.
|
|
Disconnect submitting hose (9) from the tank of a brake liquid and separate a socket (10) blocks ABS. Take a socket aside.
|
Clear area round connections of brake tubes (13), disconnect them and закупорьте open apertures.
Remove block ABS.
|
|
Give fixture and remove arm ABS.
|
|
|
Remove скобу (16) fastenings of a submitting tube to the main cylinder, disconnect a tube (17) and turn out nuts (18) fastenings of the main cylinder (19).
|
Remove the old main cylinder and rearrange a hose (20) on the new cylinder.
Installation is made upside-down. After installation pump over coupling (the Section Prorolling of coupling and its executive cylinder see).
|
|
The executive cylinder
|
|