Tyre out the car on the lift, establish selector AT lever in position P and cock a lay brake.
|
Substitute under drain stopper АТ capacity for liquid gathering. Turn out a stopper and lower ATF.
|
|
At replacement ATF preliminary it is necessary to warm up it, therefore be attentive and do not burn a hand a following liquid. |
Tighten a stopper with a new sealing ring.
Disconnect from АТ a final hose and закупорьте it.
Connect to final aperture АТ the device for washing and lower the car on the earth.
Fill in АТ 4 l of a liquid according to requirements (the Section Check of levels of liquids, the control of leaks see).
Lower the hose end in a measured vessel in capacity not less than 2 l and start the engine. At being in position P selector AT lever lower 2 l old ATF then muffle the engine.
Fill in АТ 2 l fresh ATF. Start the engine.
At being in position P selector AT lever lower 1 l old ATF then muffle the engine.
Поддомкратьте the car also establish it on props.
Remove a hose of the device of washing and connect to АТ a final hose with new consolidations. Fix a hose with effort 27 Nm.
Lower the car on the earth.
Cock a lay brake, squeeze out a pedal of a brake and start the engine.
Warm up ATF to temperature 80 hailstones.
Check up and if necessary modify level ATF (the Section Check of levels of liquids, the control of leaks see).
|
|