Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
- Manual box of a gear change
   Transmission identification
   The general information
   Removal and installation of a casing of the lever of a gear change
   Adjustment, removal and installation of a drive of a gear change and the ignition lock
   Replacement of the handle of the lever of a gear change
   Removal and installation Manual transmission of 4-cylinder engines
   Removal and installation Manual transmission of diesel engines V6
   Removal and installation Д/В of lanterns of a backing
   Replacement of epiploons of power shafts
   Design and transmission major repairs
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Курсы Испанского языка для начинающих. Порно на
Русское порно на сайте
заказ виагры

Removal and installation of a casing of the lever of a gear change



  1. Remove the central console (the Body see the Head).
  1. Include 4th transfer and fix Manual transmission in this position by means of the special adaptation (2) or screw-drivers in diameter of 4 mm.

The lock core should not fail in an aperture. Give a bolt of the hinge (3).

  1. Turn out bolts (4) fastenings of a casing of the lever of a gear change and separate a socket (2) electroconductings of the lock of ignition.
  1. Remove a casing.



  1. Establish a casing into place, join a socket of electroconducting of the lock of ignition and fill electroconducting in a casing.
  2. Establish an air line of system of ventilation and tighten bolts of fastening of a casing, having paid attention to it of 2 directing pins (arrow).
  3. Include 4th transfer and insert a clamp (5) into an aperture in a casing.
  4. Tighten a hinge bolt, take from Manual transmission and a casing keeping adaptations and close an aperture on Manual transmission a plastic stopper.
  5. Make sure of serviceability of inclusion of each transfer, and also that the ignition key can be taken from the lock by the chosen transfer of a backing.
  6. Establish the central console.