Saab 9-5

Since 1997 of release

Repair and car operation

Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
- Manual box of a gear change
   Transmission identification
   The general information
   Removal and installation of a casing of the lever of a gear change
   Adjustment, removal and installation of a drive of a gear change and the ignition lock
   Replacement of the handle of the lever of a gear change
   Removal and installation Manual transmission of 4-cylinder engines
   Removal and installation Manual transmission of diesel engines V6
   Removal and installation Д/В of lanterns of a backing
   Replacement of epiploons of power shafts
   Design and transmission major repairs
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Материал с сайта

Replacement of epiploons of power shafts

Epiploon and sealing ring of the left power shaft


  1. Поддомкратьте the car also remove the left forward wheel.
  1. Take a power shaft from Manual transmission (2) and remove holders (3) brake hoses and wires ABS.
  1. Turn out a bolt (4) fastenings of a spherical support of a suspension bracket to a rotary fist, pull out a spherical support and fix it by means of wooden бруска, established between the lever and the suspension bracket stabilizer.
  2. Turn a wheel to the right and pull on itself the holder of a rack of a suspension bracket. The power shaft leaves from Manual transmission. Lay a power shaft on the suspension bracket lever.
  1. Take an epiploon by means of the special adaptation.
  1. Remove the case of an epiploon and replace its sealing ring.
  1. Establish the epiploon case.
  2. Запрессуйте a new epiploon in the case, preliminary having greased its pure трансмиссионным with oil.
  3. Make sure that a power shaft pure and get it in Manual transmission.
  4. Establish a spherical support of a suspension bracket and other acting in film components.
  5. Check up level трансмиссионного oils and if necessary modify its level.

Epiploon of the right power shaft


  1. Remove an intermediate shaft (Coupling and power shafts see the Head).
  1. Take an old epiploon by means of the big screw-driver.
  1. Запрессуйте a new epiploon also establish an intermediate shaft.