Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
The general data and security measures
Sbrasyvanie pressure in fuel system
- The power supply system of petrol engines
Principle of functioning of a control system of fuel injection
Removal and installation of a sleeve of an air inlet and the case of the air filter
Removal and installation of gauges MAF, MAP, IAT and the gauge of temperature/pressure of air of pressurisation
Removal and installation of a tube of forced air
Removal and installation of the case of a throttle
Removal and installation of the control valve of forced air
Removal and installation перепускного the valve турбокомпрессора
Removal and installation турбокомпрессора
Removal and installation интеркулера
Removal and installation of a pedal of gas, adjustment of a cable of a drive throttle заслонки
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of assemblage of the fuel pump and the gauge of a stock of fuel
Removal and installation of a fuel distributive highway and injectors
Removal and installation of a regulator of pressure of fuel
+ The power supply system of diesel engine V6
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of gauges MAF, MAP, IAT and the gauge of temperature/pressure of air of pressurisation
Gauge MAF
|
|
|
|
Separate a socket of gauge MAF and ослабьте collars of its fastening.
|
Remove gauge MAF, if necessary replace it.
Installation is made upside-down.
|
|
The arrow put on the case of the gauge, should specify in a direction of an air stream. |
|
|
Gauge MAP
|
|
|
|
Remove the top cover of the engine, separate a socket and remove the gauge.
|
|
|
Removal of gauge MAP of engines V6. |
At installation grease a carving of the gauge with vaseline. On engines V6 check up a condition of sealing rings of the gauge and if necessary replace them.
|
|
Gauge IAT
|
|
Gauge IAT is used only on 4-cylinder engines. |
|
|
|
|
Remove a rubber cover of a socket, separate it and remove gauge IAT.
|
Check up a condition of a sealing washer and if necessary replace it.
At installation grease a carving of the gauge with vaseline.
|
|
The gauge of temperature/pressure of air of pressurisation
|
|
On 4-cylinder engines the gauge of absolute pressure of air of pressurisation, and on engines V6 – the combined gauge of temperature/pressure of air of pressurisation is used. |
|
|
|
|
Separate a socket and remove the gauge.
|
|
|
Removal of the gauge of temperature/pressure of air of pressurisation. |
At installation grease a carving of the gauge with vaseline. On engines V6 check up a condition of sealing rings of the gauge and if necessary replace them.
|
|
|
|