Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
The general data and security measures
Sbrasyvanie pressure in fuel system
- The power supply system of petrol engines
Principle of functioning of a control system of fuel injection
Removal and installation of a sleeve of an air inlet and the case of the air filter
Removal and installation of gauges MAF, MAP, IAT and the gauge of temperature/pressure of air of pressurisation
Removal and installation of a tube of forced air
Removal and installation of the case of a throttle
Removal and installation of the control valve of forced air
Removal and installation перепускного the valve турбокомпрессора
Removal and installation турбокомпрессора
Removal and installation интеркулера
Removal and installation of a pedal of gas, adjustment of a cable of a drive throttle заслонки
Removal and installation of a fuel tank
Replacement of the fuel filter
Removal and installation of assemblage of the fuel pump and the gauge of a stock of fuel
Removal and installation of a fuel distributive highway and injectors
Removal and installation of a regulator of pressure of fuel
+ The power supply system of diesel engine V6
+ Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation перепускного the valve турбокомпрессора
4-cylinder engines
|
|
|
|
Uncover and separate a multicontact socket of electroconducting of the engine.
|
|
|
Separate a socket of electroconducting of the valve (3 on an illustration), give both fixing nuts (4) and ослабьте обтекатель a windscreen.
|
Accurately extend a fixing plate (5 on an illustration) and unhook it from edge of a partition of an impellent compartment. Raise valve assemblage.
Separate the bottom multicontact socket (6 on an illustration), mark vacuum hoses (7) and disconnect them from the valve.
|
|
Extend the holder and drill fastening rivets перепускного the valve.
|
Installation is made upside-down. Do not mix vacuum hoses.
|
|
Engine V6
|
|
|
|
Loosen the a collar of fastening of a submitting tube турбокомпрессора also remove a vacuum hose with перепускного the valve.
|
Remove перепускную a tube together with the valve, and then separate from it the valve.
Installation is made upside-down
|
|
|
|