Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
The general information and preparatory operations
Check компрессионного pressure
Check of the engine by means of the vacuum gauge
- Repair of 4-cylinder petrol engines
Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
Removal and installation of a head of cylinders and натяжителя приводной chains
Removal and installation of camshafts and valves, estimation клапанных backlashes
Check and replacement приводной chains
Replacement of a belt of a drive of auxiliary units
Replacement of epiploons and pulley of a cranked shaft
Replacement of the oil pump
Removal and pallet installation картера
Removal and installation of an arm of the filter, the thermostat and редукционного the valve of system of greasing of the engine
Check of pressure of impellent oil
Removal and installation of the power unit
Removal and installation of a cover of drive ГРМ
Check and replacement of a chain of a drive of balancing shaft and their asterisks
+ Repair of 6-cylinder petrol engines
+ Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of pressure of impellent oil
|
|
Поддомкратьте the car also establish it on props. Substitute under the oil filter capacity for gathering of impellent oil.
|
|
Give a hollow bolt of fastening of a tube турбокомпрессора to an arm of the oil filter (2 on an illustration) and allow to oil to flow down.
|
Establish under a hollow bolt a hose with a manometre and tighten a bolt. Arrange a manometre so that it was visible from a place of the driver.
|
|
Watch that the hose did not concern hot and sharp subjects. |
Lower the car on the earth, start the engine and consider manometre indications. Compare the obtained data to requirements of Specifications.
After measurement allow to the engine to work on single turns to lower speed турбокомпрессора then muffle the engine.
Installation is made upside-down. If necessary modify level of impellent oil.
|
|
|
|