Saab 9-5

Since 1997 of release

Repair and car operation


Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
   The general information and preparatory operations
   Check компрессионного pressure
   Check of the engine by means of the vacuum gauge
   - Repair of 4-cylinder petrol engines
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
      Removal and installation of a head of cylinders and натяжителя приводной chains
      Removal and installation of camshafts and valves, estimation клапанных backlashes
      Check and replacement приводной chains
      Replacement of a belt of a drive of auxiliary units
      Replacement of epiploons and pulley of a cranked shaft
      Replacement of the oil pump
      Removal and pallet installation картера
      Removal and installation of an arm of the filter, the thermostat and редукционного the valve of system of greasing of the engine
      Check of pressure of impellent oil
      Removal and installation of the power unit
      Removal and installation of a cover of drive ГРМ
      Check and replacement of a chain of a drive of balancing shaft and their asterisks
   + Repair of 6-cylinder petrol engines
   + Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of a belt of a drive of auxiliary units

Check of a condition and tension of a belt of a drive of auxiliary units is described in Section Check of a condition and a tension of a belt of a drive of auxiliary units.

Removal of components in the right part of an impellent compartment

2 — Tube ГУР
3 — the Wedge
4 — the Right support of the engine

5 — Gauge MAF
6 — the Right support of the engine
7 — the Elevating eye of the engine


 PERFORMANCE ORDER

    Uncover the inlet pipeline. Поддомкратьте the car also establish it on props and turn the right forward wheel outside then lift the receiver pump GUR from a frame (2 on an illustration). Establish a wedge between the pallet картера and a frame (3 on an illustration). Remove a rubber saddle of gauge MAF (5 on an illustration) and take him aside. Remove the right support (4 on an illustration) the engine together with a collar. Unload натяжитель a belt and fix it in this position, having inserted into its aperture прутковый a key (3 mm). Remove приводной a belt from pulleys. Installation is made upside-down.