Saab 9-5

Since 1997 of release

Repair and car operation



Saab 9-5
+ Cars Saab 9-5
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
   The general information and preparatory operations
   Check компрессионного pressure
   Check of the engine by means of the vacuum gauge
   - Repair of 4-cylinder petrol engines
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
      Removal and installation of a head of cylinders and натяжителя приводной chains
      Removal and installation of camshafts and valves, estimation клапанных backlashes
      Check and replacement приводной chains
      Replacement of a belt of a drive of auxiliary units
      Replacement of epiploons and pulley of a cranked shaft
      Replacement of the oil pump
      Removal and pallet installation картера
      Removal and installation of an arm of the filter, the thermostat and редукционного the valve of system of greasing of the engine
      Check of pressure of impellent oil
      Removal and installation of the power unit
      Removal and installation of a cover of drive ГРМ
      Check and replacement of a chain of a drive of balancing shaft and their asterisks
   + Repair of 6-cylinder petrol engines
   + Repair of 6-cylinder diesel engines
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of a cover of drive ГРМ

More low described procedure assumes that the power unit is removed from the car.

The components removed for providing of access to a cover of drive ГРМ

1 — ShChup of level of impellent oil
2 — the Intermediate roller

3 — Pump GUR
4 — the Water pump


 PERFORMANCE ORDER

    Take out щуп level of impellent oil and remove an intermediate roller (2 on an illustration). Remove pump GUR and its arm with an elevating eye (3 on an illustration). Remove the water pump and the plug with sealing rings (4 on an illustration). Remove the pallet картера and disconnect from it a hose сапуна картера. Directing plug leave in the block of cylinders. Wipe the flowed out oil. Remove a pulley of a cranked shaft (the Section Replacement of epiploons and a pulley of a cranked shaft see).
    Turn out directing pins from a cover of drive ГРМ a way нарезания in them carvings (8) (fixture (8 and 9) covers (10) drive ГРМ).
    Turn out all bolts of fastening of a cover of drive ГРМ (9 on an illustration). Uncover, since its bottom edge, and then, moving it upwards-downwards not to damage a lining of a head of cylinders. Carefully clear of the consolidation rests all interfaced surfaces and then put on them on the centre the platen of hermetic Loctite in 518 thickness of 1 mm. Establish a cover of drive ГРМ, and screw bolts of its fastening, but yet do not tighten them. Establish into place directing pins of a cover. Tighten bolts of fastening of a cover of drive ГРМ with effort 22 Nm. Check up a condition of sealing rings of the water pump and if necessary replace them.

The further installation is made in an order, the return to an order of dismantle of components.